MCQ Surveying And Levelling (Part 1)- Civil Engineering MCQ

MCQ Surveying And Levelling (Part 1)

MCQ Surveying And Levelling

Question No. 01
To avoid large centering error with very short legs, observations are generally made
(A) To chain pins
(B) By using optical system for centering the theodolite
(C) To a target fixed on theodolite tripod on which theodolite may be fitted easily
(D) All the above

Question No. 02
Different grades are joined together by a
(A) Compound curve
(B) Transition curve
(C) Reverse curve
(D) Vertical curve

Question No. 03
Which of the following methods of theodolite traversing is suitable for locating the details which are far away from transit stations?
(A) Measuring angle and distance from one transit station
(B) Measuring angles to the point from at least two stations
(C) Measuring angle at one station and distance from other
(D) Measuring distance from two points on traverse line

Question No. 04
The line of collimation method of reduction of levels, does not provide a check on
(A) Intermediate sights
(B) Fore sights
(C) Back sights
(D) Reduced levels

Question No. 05
Which of the following methods of contouring is most suitable for a hilly terrain?
(A) Direct method
(B) Square method
(C) Cross-sections method
(D) Tachometric method

Question No. 06
The chord of a curve less than peg interval, is known as
(A) Small chord
(B) Sub-chord
(C) Normal chord
(D) Short chord

Question No. 07
The size of a plane table is
(A) 750 mm × 900 mm
(B) 600 mm × 750 mm
(C) 450 mm × 600 mm
(D) 300 mm × 450 mm

Question No. 08
If the reduced bearing of a line AB is N60°W and length is 100 m, then the latitude and departure respectively of the line AB will be
(A) +50 m, +86.6 m
(B) +86.6 m, -50 m
(C) +50 m, -86.6 m
(D) +70.7 m, -50 m

Question No. 09
A lemniscate curve between the tangents will be transitional throughout if the polar deflection
angle of its apex, is

Question No. 10
Contour interval is
(A) Inversely proportional to the scale of the map
(B) Directly proportional to the flatness of ground
(C) Larger for accurate works
(D) Larger if the time available is more

MCQ Surveying And Levelling Answers (Part 1)

Question No. 1: C

Question No. 2: D

Question No. 3: B

Question No. 4: A

Question No. 5: D

Question No. 6: B

Question No. 7: B

Question No. 8: B

Question No. 9: D

Question No. 10: A

Leave a Reply

Your email address will not be published. Required fields are marked *

Open

Join Telegram